(425) 375-0521

Call for Service

(425) 375-0521

Send An Email

son@homesquadusa.com

Get A Quote

Let’s Talk About Home Squad Inspections

With a combined experience of over 50 years our inspection practices are above and beyond those of our competitors. From our 21 point AC and Furnace checklist to our 12 point water tank inspections we make sure our customers have every base covered. See our complete list of point inspections here. 

21 Point AC and Heat Pump Inspection

  • INSPECT wiring and control circuit
  • INSPECT blower assembly
  • VISUALLY inspect heat exchanger(s)
  • CHECK/ADJUST fuel and air mixture
  • INSPECT venting and combustion air
  • CHECK flame rectification and clean sensor
  • CHECK/ADJUST inlet and outlet gas pressure
  • INSPECT for gas leaks
  • INSPECT safety controls
  • INSPECT electrical components
  • VERIFY temperature rise (dry bulb)
  • VERIFY flue temperature and draft
  • VERIFY motor amps
  • CLEAN the control panel, burners, and wipe down equipment
  • VERIFY supply and return air static pressures
  • VERIFY correct voltage to furnace equipment
  • TEST and measure carbon monoxide
  • INSPECT thermostat operation and programming
  • CLEAN or replace media filter or clean Electronic Air Cleaner
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

21 Point GAS Furnace Inspection

  • INSPECT wiring and control circuit
  • INSPECT blower assembly
  • VISUALLY inspect heat exchanger(s)
  • CHECK/ADJUST fuel and air mixture
  • INSPECT venting and combustion air
  • CHECK FLAME rectification and clean sensor
  • CHECK/ADJUST inlet and outlet gas pressure
  • INSPECT for gas leaks
  • Inspect safety controls
  • INSPECT electrical components
  • VERIFY temperature rise (dry bulb)
  • VERIFY flue temperature and draft
  • VERIFY motor amps
  • CLEAN the control panel, burners, and wipe down equipment
  • VERIFY supply and return air static pressures
  • VERIFY correct voltage to furnace equipment
  • TEST and measure carbon monoxide
  • INSPECT thermostat operation and programming
  • CLEAN or replace media filter or clean Electronic Air Cleaner
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

12 Point Electric Furnace Inspection

    • INSPECT fuses
    • INSPECT limit switches
    • VERIFY sequencers operating properly
    • VERIFY heat strip amp draw
    • VERIFY continuity of heat strips
    • VERIFY blower motor amps
    • INSPECT low voltage wiring
    • INSPECT line voltage wiring
    • CLEAN or replace media filter or clean Electronic Air Cleaner
    • INSPECT thermostat operation and programming
    • CYCLE equipment to verify operation
    • PROVIDE a written diagnostic report of findings

11 Point Makeup Air System Inspection

  • VERIFY fan hood triggers system
  • VERIFY Heat strip amps
  • VERIFY blower amps
  • INSPECT current sensor installation and wiring
  • VERIFY current sensor setting
  • INSPECT blower wheel condition
  • WIPE down equipment
  • CHANGE filter
  • INSPECT thermostat operation and programming
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

14 Point Tankless System Inspection

  • VERIFY hot water temperature
  • VERIFY flame visibility and performance
  • INSPECT and clean burners
  • INSPECT and clean flame sensor
  • INSPECT and clean spark rod
  • INSPECT and clean inlet filter
  • VERIFY operation of relief valve
  • CHECK for and investigate any fault codes
  • INSPECT venting system
  • FLUSH system with white distilled vinegar
  • CLEAN equipment with pressurized air
  • WIPE down equipment
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

12 Point Hot Water Tank Inspection

  • VERIFY hot water temperature
  • VERIFY flame visibility and performance
  • VERIFY temperature setting at tank
  • INSPECT and clean burners
  • INSPECT for rust and leaks
  • VERIFY operation of relief valve
  • INSPECT venting system
  • DRAIN 5 gallons of water from drain valve
  • VERIFY earthquake straps intact and tight
  • WIPE down equipment
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

13 Point Indoor Unit Inspection

  • INSPECT and change batteries in remote if needed
  • INSPECT and clean filters
  • INSPECT and clean blower wheel
  • INSPECT and clean indoor housing
  • INSPECT and clean condensate line
  • INSPECT and clean indoor coil
  • VERIFY condensate pump operation
  • VERIFY correct voltage and communication to equipment
  • FLUSH drain line
  • INSPECT flare connections and refrigerant lines
  • INSPECT and clean louvers
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

13 Point Outdoor Unit Inspection

  • INSPECT and clean the outdoor condensing unit
  • INSPECT the indoor coil
  • INSPECT for visible refrigerant leaks
  • INSPECT flare connections and refrigerant lines
  • INSPECT wiring and control unit
  • INSPECT electrical components
  • VERIFY correct voltage to equipment
  • INSPECT and clean blower wheel
  • WIPE down equipment
  • INSPECT and clean fan blade
  • INSPECT safety controls
  • CYCLE equipment to verify operation
  • PROVIDE a written diagnostic report of findings

Why Choose Home Squad?

Other than being your appliance repair super heroes here are just a few reasons why you should choose Home Squad technicians to take care of your appliance repair needs.

No Shortcuts

Thorough and to the rescue! Our licensed technicians use only OEM factory parts for any appliance repair.

Straight Forward Pricing

All of our jobs are priced on a bid basis. What does this mean? Instead of a flat, hourly fee and appointment pricing, we come in and assess the job, then provide our customers with the bid for the project. 

"Kind and on time"

We pride ourselves on always being to our calls within the scheduled appointment time. With our 30 minute ETA calls, branded vehicles, uniforms, and our "Can Do" attitude, Home Squad is a cut above the competition!

Safety focused

All of our technicians undergo CDC guideline training and have been vaccinated for your safety. Technicians also wear masks when applicable. 

How We Work

Before we get started, let's give you an overview of how we operate.

Schedule your appointment

Give us a call and tell us your appliance problem! We'll get you on the schedule and get a technician out to you as soon as possible!

l

Get your estimate

Once our technician arrives and diagnoses your problem they'll provide you with an estimate for the scope of the work. Choose to go with our estimate that same day and your initial service fee is waived!

Schedule Your repair

If our technician can't repair your appliance on the spot then we'll order the parts and give you a call when they're in to get your repair finished!